Fortunately, you can easily replace your broken springs, especially if your Sectional garage doors with broken springs that needs to be fixed. Extension springs run horizontally along a track on each side of the door. They do not have as much tension, so you can usually handle them on your own with a little patience and courage. Just be sure to use the right tools and number of turns to avoid damaging the springs.
Signs of broken springs
One of the most common problems with sectional garage doors is a broken spring. A broken spring causes the door to stop working properly. To check if the spring is broken, look for two distinct signs. If you notice a gap between the two spring pieces, it may be an extension spring. If the spring is broken, the door won’t open or close correctly, and it may also look wonky. If you notice any of these signs, it’s probably time to call a professional for sectional garage door repair.
Whether your door is sectional or single-piece, it should have two torsion springs. The torsion springs twist to absorb the weight of the garage door. If one spring is broken, the other one will take the strain. Broken springs can make it difficult to lift the door or move it manually. You should replace the spring immediately if you notice any of these problems.
Cost of replacing broken springs
The most common way to fix broken extension springs on sectional garage doors is to replace them with new ones. These springs are made to last up to seven to twelve years. Extension springs are long and extend up from the garage door horizontal track. When the door is lowered, they tighten and pressurize to create spring action. There are safety cables attached to these springs so that they won’t fall out if they break. The cost of replacing these springs can range from $50 to $100.
Extension springs tend to stretch over time, so they will need to be measured accurately. To measure a spring, you must remove it from the door and compress it. Then, you will need to count the number of coils in the spring. If your springs are bent or broken, you’ll need to measure the overall length. In most cases, you can buy multiple springs, if needed.
Maintenance of springs
If your sectional garage door has broken springs, it may be time for a spring replacement. While spring replacement is a simple process, you should know how to properly maintain the springs so that they won’t break again. When you have broken springs, it is best to hire a professional to replace them. Professionals will offer different grades and cost ranges for springs, from economy to premium. Top of the line springs may be guaranteed for life. Economy springs can last about five years under normal use.
It is recommended to lubricate the springs at least twice a year. This will prevent them from rusting, which can cause them to wear out more quickly. Using a silicone-based lubricant is a great way to prolong the life of springs. Professionals also have the right tools and training to tune up the springs. Check your springs regularly to avoid rust.
Cost of replacing torsion springs
The cost of replacing torsion springs on sectionals garage doors may be a considerable expense. This is because a torsion spring is responsible for lifting and lowering the door. The springs must be properly lubricated to keep them from wearing out. In addition to replacing the springs, the garage door should also have a center bearing, which prevents the shaft from rubbing against the spring anchor bracket.
Before attempting to replace the springs, measure the springs to find out their overall length. Each spring has a different wind direction, so if your door has two springs, you must know which one is broken. Using a measuring hook between the two coils, measure the springs’ overall length. Once you’ve measured the springs, divide them by 20 and 40 to determine their wire diameter.
